VenuSub Bolt - Cages à cupules inversées V1 - Système de chasteté masculine - Compatible EasyCB

VenuSub

Unlock The Goddess In You

The VenuSub Bolt series of male chastity products is inspired by (and directly compatible with) the popular EasyCB chastity cages. The goal of this line of products is to make an easy-to-manufacture, easy-to-use, and highly comfortable chastity cage system which is secured not with a traditional key, but instead using socket head screws and square bolts. This is preferable in situations where there is no keyholder, and the wearer wants to swap out cages quickly and easily. It is also cheaper to manufacture, as screws and bolts are cheaper than the locking options.

These are the first iteration of the inverted cup cages. They the following ring options:
- VenuSub Bolt Flat Rings V1
- EasyCB v5, however, they fit rather tightly.

There are numerous sizes for a customizable experience. This allows for a very gradual "training curve" if you want to work towards the more restrictive sizes.

Here is a guide to decoding the part numbers of the STL files:
VSB-CIS1-xx
VSB = VenuSub Bolt series
CIS1 = Cage, Inverted, Solid cup, version 1
xx = the length of the inverted portion, in millimeters

Preferred Material: Unadulterated White ABS

Nozzle Size: 0.4mm or smaller
Layer Height: 0.2 mm
Outlines/Shells: 2
Infill: 100%
s: None
Additional Slicer Notes: Print the part as solid as possible.

Post Processing Suggestion:
1. Sand the rough edges and imperfections down using 220 grit sandpaper. (Make sure not to breathe in the dust!)
2. Put square nuts in the side holes, and screw bolts in to keep them in place. gently tighten the screws, then loosen them by about 1/4 turn.
3. Dip just over half of the part (the half with the bolts and nuts) in liquid acetone for 10 seconds. "Feather" the dipping line by gently moving/rotating the part so that the liquid interface is never in the same spot for more than a moment.
4. "Shake off" excess pooled acetone by moving your arm quickly in a circular motion 2-3 times, like you were preparing to throw the part. Make sure no liquid remains in the small holes or on the surface. DO NOT BLOW ON THE PART or you will get white spots.
5. Carefully remove the bolts, making sure to not touch the wet surface. Blow briefly but firmly in the bolt holes to clear the excess acetone. Do not dry the surface with your breath, you will get white spots.
6. Let dry for at least 10 minutes. Ideally you will hold the part by hand for 1-2 minutes, then carefully set the part down on a smooth surface like glass, balanced so that only 2-3 points are touching the surface. DO NOT TOUCH THE WET SURFACE UNTIL THEN!
7. Dip the second half (the half without the nuts) for 10 seconds, making sure not to miss any areas. Feather the dipping line again.
8. "Shake off" again, making sure no liquid acetone remains on the surface.
9. Let dry for at least 10 minutes before handling gently, again by holding for a few minutes and then setting it on a smooth surface with minimal .
10. Set the part in a safe place and allow to dry for a full 12-24 hours before use.

Additional Required Hardware:
Each VenuSub Bolt cage and ring combo needs the following hardware:
- 2x M3x10mm socket head bolts
- 2x M3 square nuts, thin variant (1.8mm thick)
- At least 1x 2.5mm hex key

You can convert your 2.5mm hex key into an actual key with this model.