VenuSub Bolt - Flat Rings V1 - Système de chasteté masculine - Compatible EasyCB

VenuSub

Unlock The Goddess In You

The VenuSub Bolt series of male chastity products is inspired by (and directly compatible with) the popular EasyCB chastity cages. The goal of this line of products is to make an easy-to-manufacture, easy-to-use, and highly comfortable chastity cage system which is secured not with a traditional key, but instead using socket head screws and square bolts. This is preferable in situations where there is no keyholder, and the wearer wants to swap out cages quickly and easily. It is also cheaper to manufacture, as screws and bolts are cheaper than the locking options.

These are the first iteration of the flat rings. They the following cage options:
- VenuSub Bolt External Flying Head Cages V1
- VenuSub Bolt Flat Cages V1
- VenuSub Bolt Inverted Cup Cages V1
- EasyCB v5, however, only the XXS and XS sizes are suitable for wearing under clothing, as the angle that the cages attach to the rings was changed to be more ergonomic.

There are numerous sizing options to allow an extremely customizable experience. If you need larger sizes, please let me know and I will make them and add them here for no additional cost.

Here is a guide to decoding the part numbers of the STL files:
VSB-RFL1-xx
VSB = VenuSub Bolt series
RFL1 = Ring, FLat, version 1
xx = the size of the ring, in millimeters

Preferred Material: Unadulterated White ABS

Nozzle Size: 0.4mm or smaller
Layer Height: 0.2 mm
Outlines/Shells: 2
Infill: 100%
s: None
Additional Slicer Notes: Print the part as solid as possible.

Post Processing Suggestion:
1. Sand the rough edges and imperfections down using 220 grit sandpaper. (Make sure not to breathe in the dust!)
2. Dip just over half of the part in liquid acetone for 10 seconds. "Feather" the dipping line by gently moving/rotating the part so that the liquid interface is never in the same spot for more than a moment.
3. "Shake off" excess pooled acetone by moving your arm quickly in a circular motion 2-3 times, like you were preparing to throw the part. Make sure no liquid remains in the small holes or on the surface. DO NOT BLOW ON THE PART or you will get white spots.
4. Let dry for at least 10 minutes. Ideally you can hang the part with the hook only touching the dry area. DO NOT TOUCH THE WET SURFACE UNTIL THEN!
5. Dip the second half for 10 seconds, making sure not to miss any areas. Feather the dipping line again.
6. "Shake off" again, making sure no liquid acetone remains in the holes or on the surface.
7. Let dry for at least 10 minutes before handling gently, again hanging by the dry section you were grabbing.
8. Set the part in a safe place and allow to dry for a full 12-24 hours before use.

Additional Required Hardware:
Each VenuSub Bolt cage and ring combo needs the following hardware:
- 2x M3x10mm socket head bolts
- 2x M3 square nuts, thin variant (1.8mm thick)
- At least 1x 2.5mm hex key

The loops are designed for 10 meters of gutted 550 paracord with ends melted to a smooth taper. You can either tie a harness using all 3 loops, or just the top 2, depending on your personal preference.

You can convert your 2.5mm hex key into an actual key with this model.