CREALITY SONIC PAD HOLDER - MOD.2 - (For 40mm profile)

There are currently two models, each with three variations, check which one best suits your needs:

Model 1 (Ender 6): https://cults3d.emulatorsite.com/en/3d-model/tool/soporte-para-creality-sonic-pad

Model 1 (20mm profile anchor): https://cults3d.emulatorsite.com/en/3d-model/tool/soporte-para-creality-sonic-pad-para-perfil-20mm

Model 1 (Anchor profiles 40mm): is ready, will be published soon (let me know if you can't wait).

Model 2 (Ender 6): https://cults3d.emulatorsite.com/en/3d-model/tool/soporte-para-creality-sonic-pad-mod-2-ender-6-y-adaptable-a-otras

Model 2 (20mm profile anchor): https://cults3d.emulatorsite.com/en/3d-model/tool/soporte-para-creality-sonic-pad-mod-2-para-perfil-20mm

Model 2 (40mm profile anchor): https://cults3d.emulatorsite.com/en/3d-model/tool/soporte-para-creality-sonic-pad-mod-2-en-perfil-40mm

This bracket can easily be used on many printers, it is designed to anchor to a 40mm vertical profile.

Both the bracket and the fixture, can be varied in position, allowing right and left and up or down, this way you can adjust the side and also part of the height.

For the connection, it will be necessary to remove the screen legs, use the same screws and add 2 (M3*8) for the lower fixings normally not used. By means of this anchorage, a better fixation is obtained, being the screen fastened in 4 points to the .

This model is designed for s who need to change the viewing angle on the screen frequently, with the adjustment work falling on the axis of the bracket instead of the upper screws of the screen. If you change the pitch position frequently, it will not be necessary to loosen and tighten the nut each time, just keep the locking nut slightly tightened and the screen will be allowed to move without the need to constantly use the nut.

The fixing of the , allows to hide the screws with some covers, also to do without covers and to use these screws to mount rings that facilitate the fixation of the cables. In this model the cable fixing is included, the covers are not necessary, if you want you can the base and screw cover available in my profile, they look great.

The model is sturdy and holds highly steady during printing, it does not wobble or shift position with printer vibrations.

The screen will be firmly anchored, allowing movement or remove it easily by pulling out its shaft.

Washers are enclosed to allow better fixing and movement, it will be necessary to add 1 of 0.50mm on each shaft t, both the fixing and pitching of the screen, in addition it is advisable to include a 1mm washer before the pitch nut. By means of these washers the correct adjustment and movement is completed without component wear.

It is recommended that at least 35% density and 3 or more layers and walls be printed.