9 commentaires

Ho friend, its possible to have a step file of the chain for the extender?

These clips are way too small? How did you fit it on. I printed them and it wont go on because of how thick the cable is.

The heater cable issue is solved. I went to Tinkercad and thickened the clip and put a semicircular path for the thicker cable. I also printed it on its side for strength. Thanks for the design.

I made the chain, but the thickness of the cable is more than the height of the chain. The clips break as they can't bend over the cable. The cable is 8.5mm and the chain opening is 6.70mm. Is there a formed clip? I'm try to avoid reprinting everything. Can you offer an alternative? Thanks Stu

Hi there

I printed this design of yours, it looks cool but the extruder hits against the handle when you print to the full size of the bed. it is in the way. it needs to be lower.

I am just giving you .

regards

Hennie

Hi there

I printed this design of yours, it looks cool but the extruder hits against the handle when you print to the full size of the bed. it is in the way. it needs to be lower.

I am just giving you .

regards

Hennie

Hi, saw your Ender 3 S1 Pro Cable Chain and found it perfect because it fits the same way in the CR-10 Smart Pro. One question, since the printer is a larger print volume (300x300x400), how many chains/clips would I have to print? Also, what's the best orientation for the extruder and z axis clips to minimize s? Thank you.

Hello,

what filament do you recommend for printing?

Thanks very much

Good day

I have been trying to edit your "z-axis " as there are week spots that break easily which I would have liked to add fillets or extra bracing in.

Any change you can do it, or else perhaps share the design file with me... I am using Fusion 360

The biggest concern area is on the clip section that clips onto the chain that goes down to the bottom of the machine.

Regards