Hi! Can the no mess funnel be done with the hole to the side so it sits flush on the bottom of the tumbler while filling?
- 0 j’aimes
👋 Bonjour à tous ! Ce fil de discussion est public, alors restons gentils et respectueux. Pas de publicité, de spam ou de choses désagréables !
🇦🇺 Pays du membre : Australie
🌐 Langue préférée du membre : Anglais. Vous pouvez traduire en ligne via DeepL.
💡 Vous faites référence à un modèle en particulier ? Ajoutez le lien, le titre ou le numéro du modèle.
🖼️ Vous souhaitez publier des photos ? Utilisez un hébergeur gratuit comme ImgBB et collez les liens dans le message.
✍️ Astuces de rédaction : Utilisez le format Markdown pour structurer vos textes et les rendre plus lisible
Écrivez votre message :
5 commentaires
So there is 3 files attached with one being on the side of the funnel
- 0 j’aimes
Hmmm all 3 files I have ed are all middle holes
- 0 j’aimes
Ohh strange I thought I ed it once I get home in about 1 hour I will once again and I have another with a larger funnel area also sorry for the confusion
- 0 j’aimes
Hello! Do you have the glitter funnel in an STL file? Also how tall is the funnel?
Thank you!
- 0 j’aimes
There is STL files attached when you it
- 0 j’aimes
Hi,
I haven't received the newest design it's still sending me to the older one. Also is it possible to get a thinner tube one done as the hole on my 20oz is oval and smaller then your 8mm
- 1 j’aime
If you try to re the files theirs 3 attached with center hole and offset plus one with a cutout in the tube
- 0 j’aimes
Good Morning,
I just printed this design and it's too large for the tumbler hole. Could you please fix the tube part to make it a bit smaller? and if possible sent me the fixed file
- 1 j’aime
when ing the file their should of been 2 different files one with a 10mm and one with a 7.8mm hole for various snowglobe cups
- 0 j’aimes
I believe the hole needs to be on the outside as the whole isn't in the centre of the glass either
- 1 j’aime
No i found that the hole in the middle works great
- 1 j’aime
Both designs are still there if you prefer center or offset
- 0 j’aimes
I have used the settings stated and it just will not print the offset version. It immediately chops the print up on one end. any clue why?>
That’s very odd maybe make sure the item is flat on the bed ..? There is a face down icon in bambu studio that you can select where you would like what part to be flat
Yes I have tried that. On screen it looks like there is a slit in the seam area. Is the first layer supposed to be broken in 2 sections to complete the circle? Because it print half the circle then goes to close the circle off and chops the whole area off
I was able to print this off easy with my chosen setting I’ll take a look once I’m home and see but it was all one piece in fusion but will take a look
yes its not all one piece it print half a circle then goes to print the remaining piece after! thank you!
the deeper funnel does print as one piece not the smaller one though
did we get this figured out?
yes so i found out the model was Rotated 179' degrees when modeling you will need to rotate it 1 Degree so it sits flat if you can give me about 1 hours i can fix and re