9 commentaires

Hey, I will be honest my fdm skill's are limited, I printed all these on anycubic mono se.

But I will give it a damn good go, if I right it's orientation that is gonna be important, because of the small details across the model no side has a perfect flat surface. And the more surface area the more bed adhesion you will have.

So yea slow down your print speed could help that could reduce a pulling force that pulls it away and now let's look at how to increase surface area.

We could print it at an angle with a raft and or brim, try putting the design so lens face up and add an angle of 10° that should give lots of surface area to stick to the bed. This will introduce the need for s and we require clean up.

Or even just printing with a raft might help thinking about it.

Or we could split the model in your favourite slicer so that you now have a perfect flat surface to print from. If you slice it into 3 parts you might not even need s. I would say that would be the bottom were the feet are slice that and print that feet facing up and then the remaining body slice it in half so that you have one side with the lenses and the back plate.

I hope some of these ideas help and I hope that you get some fantastic prints with it.

Happy printing
Steve

I would also scale it up as well because with an fdm machine you just can :)

Entschuldigung, ich bin beim Warten auf Ihre E-Mail eingeschlafen, haha, ich entschuldige mich, ich sende sie jetzt

und ich habe es gerade gesendet

Okay, wie lautet deine E-Mail und ich schicke sie dir gleich zu

Ok, ich kann dir die Dateien per E-Mail schicken, wenn du möchtest.

okay, Harz oder Kunststoff, und hast du Probleme beim Herunterladen der Dateien?

Haben Sie Probleme beim Drucken, welche Art von Drucker verwenden Sie?

Hallo und vielen Dank für Ihr Interesse. Entschuldigung, mein Deutsch ist nicht sehr gut. Gibt es ein bestimmtes Design, nach dem Sie suchen, lassen Sie es mich wissen. „übersetzt mit google“