Hello, would it be possible to get instructions for installation or pictures. Because it's unclear to me how you were able to put the lid back on or did you remove the lower part.
That would be cool of you.
Thank you
- 0 j’aimes
👋 Bonjour à tous ! Ce fil de discussion est public, alors restons gentils et respectueux. Pas de publicité, de spam ou de choses désagréables !
🇩🇪 Pays du membre : Allemagne
🌐 Langue préférée du membre : Anglais. Vous pouvez traduire en ligne via DeepL.
💡 Vous faites référence à un modèle en particulier ? Ajoutez le lien, le titre ou le numéro du modèle.
🖼️ Vous souhaitez publier des photos ? Utilisez un hébergeur gratuit comme ImgBB et collez les liens dans le message.
✍️ Astuces de rédaction : Utilisez le format Markdown pour structurer vos textes et les rendre plus lisible
Écrivez votre message :
5 commentaires
For me the air channels are a little bit to tight for me. Would it be possible to get the Fusion360 or Step file to do my own changes on it? Thank you in advance.
- 0 j’aimes
Thanks for the contribution.
Just couple of questions:
Will the standard PLA for Eg: Hatchbox be sufficient?
I was thinking of getting the Ortur Air Assist and installing it? You think its a good choice?
- 0 j’aimes
I set my compressor to 0.5 bar and then I get clean cut edges, I don't know what pressure Otur delivers with what flow rate. I use this compressor https://shop.scheppach.com/kompressor-hc20si-twin-scheppach?pvari23332-0-3-1444=1628&campaignid=17378360289&adtype=pla&merchant_id=104864886&device=m&gclid=Cj0KCQiA2-2eBhClARIsAGLQ2Rl4EX4Q5SSpRAhZLQpz8w6XsXs9j2QGICg43Ryt7uYQL5rF6mqpjZYaApfGEALw_wcB
- 0 j’aimes
Hi,
what kind of filament did you use for the air assist? PLA/ABS/...?
BTW very nice design.
- 0 j’aimes
Ideal is aluminium printer at SLM, i do it with HIPS. But when you have many reflections, it will be melting.
- 0 j’aimes
did you print the HIPS filament with Snapmaker 2.0?
- 0 j’aimes
Yes, at A350 with housing and bed Temperaturen 92 degree.
- 0 j’aimes
Simply unscrew the cover, then unscrew the metal air guide. Thread the cover onto the printed part. Then put both on and first screw on the pressure part and simply turn the cover away. Finally screw the lid tight.