Scully V2 - Jeu de fléchettes en mousse éjectable - Entièrement mécanique

Hey, its half length darts. If you dont have them you can take full length dart and then cut them to make it 36mm length

There is only nerf darts in Turkey and It's diameter is 1.2 cm . What is the diameter of darts?

The diameter should be 1.2cm. Length should be around 36mm. You can make this dart from normal size dart.

I'm an engineer and want to assembly for my son. I bought the stl files and instructions and looked them. What a great work. Liked it very much. Thanks for this work. worth every liras.

Cheers mate 🙂

Hey,
As per answer for Jester it is possible with splitting parts into two but would be significantly more difficult than for Jester. So if you are going splitting route definitely first try with Jester. And if that works then i would recommend going for Floki instead of Scully as the splitting for Scully might be more complex.

Hey! No, dimensions are bit different for printability.

Hey, 20% should be fine. However keep in mind that making certain parts too heavy may cause problems so I recommend not overdoing it and sticking with the original instructions for these particular parts: cartridge, slide, magazine lifter.

i followed the instructions in the end and chose not to risk it as thats the same conclussion i came to when thinking about it. thanks for the reply i have this printing right now :)

I think resin is too weak

Thanks for the ! Sure, will make an optional version with reinforcements 🙂

Reinforced version has been added :)

Thank you :)

I dont know exact numbers but it is around +-2kg

I get 60-80 fps. Cant tell exact range but it is in par with stock foam dart blaster :)

Thank you :)

thanks :)

Thanks! 😊