de jeu SNES pour Switch

The updated version of the design is great! The cartridge sits snug enough that it doesn't fall out when tipped upside down. It only requires a little bit of force from my thumb to push it out until the thumbnail notch at the top of the cartridge is exposed.

Copying my comment from the make I posted.

Thanks for sharing the design. I printed at 50mm/s speed in my Ender V2 Neo because I was worried about the bridging across the top front but didn't have any problems.

The holder is very snug with the cartridge in it and can be a challenge to get out.

Also including an update from the designer the following day with an update from my make post. Thank you for being so responsive.

Hello All!

So I saw a person did a make and mentioned that the slot for the switch game was tight when he printed it on his Ender 3 v2. Now when I was deg this I was testing the design on my Bambu A1 Mini and everything seemed ok (wasn't too tight), but just in case I updated the hole size just a tiny bit. Now I don't want it to be too loose because I don't want the game to slide out too easily but I also don't want it to be overly tight.

If someone wouldn't mind testing this for me and letting me know that it works ok for them that would be a huge help!

Thanks!
Mike