/https://preview3d-images.cults3d.emulatorsite.com/5od8bk2opx47ko7dd8llmq3fqdlc)
I've owned many onaholes and fleshlights and have tried alls sorts of eclectic dick tech (say that 10 times fast!). This was a unique and pretty fun experience. A little awkward with just the lower half of your body getting sprayed. It's kind of like playing a cock-based game of Operation. Decent pressure, but no adjustment so your mileage may vary. For my shower, it's about a 4/10 intensity of stimulation, and hot water helps. It's most effective used just on the tip, and doesn't feel like much on the shaft.
- 0 jâaimes
Hi,
printing with "Das Filament" PETG works fine but first mistake I done is that I didn't watch the internal diameter at original scaling and my dick didn't fit into the 52-53mm so I scaled it up to 70mm which is around 2-3mm more than my penis diameter and also tried 75mm and 80mm but the effect at my glans penis is almost zero but not sure if maybe my worse water pressure and flow is the problem, so is there any recommendation about how much bigger as the dick it should be printed?
Regards VPanic
Hi, yes I would suggest this one as its a bit bigger https://cults3d.emulatorsite.com/en/3d-model/naughties/the-succubus-mouth-blowjob-masturbator-for-man-shower-head-attachment-with-t
or this one that is for different audience however the stimulation effect still works and is quite prominent
https://cults3d.emulatorsite.com/en/creations/pleasure-water-jet-shower-head-that-create-a-high-pressure-flow-of-water-in
What's the internal diameter of https://cults3d.emulatorsite.com/en/3d-model/naughties/the-succubus-mouth-blowjob-masturbator-for-man-shower-head-attachment-with-t @ 100% scaling and recommended for which ... diameter?