GROOVI MONSTER

Sliced this using PrusaSlicer 2.2 at .2mm.

I can't really hear a difference in volume using it unfortunately. But it is a fun interesting phone stand even if it doesn't amplify my phone.

I decided to try to avoid a lot of s and was curious how well it would print with s on anything over 65% overhang. You can see where the s ended up in the photos. I didn't tweak any of the stock settings in the slicer except the overhang. I did have a small area on the back side in the middle of the main body where the filament isn't bonded but in strings. Probably should have slowed it down a bit or changed some settings but I don't know much about it still.