Dragon articulé

Great model!! Awesome detail!!

The last couple of sections of the tail are a bit tight but I believe that's due to scaling the model down to 81%

Utilized McGybeer's tips with a great result.

In Cura I set:

• Initial Layer Height: 0.3 mm
• Wall Line Count: 3
• Monotonic Top/Bottom Order: On
• Infill Density 10%
• Printing Temperature: 215
• Build Plate Temperature: 70
• Initial Layer Speed: 8 mm/s
• Number Of Slower Layers: 4
• Z Hop When Retracted: On
• Z Hop Only Over Printed Parts
• Z Hop Height: 0.5 mm