UNO ARDUINO CASE LAB PORTABLE

Finally paid for this print - you can certainly see the quality in the design!

Sliced with S3D, the very few s I had just brushed off.

I'm using mine with a Uno clone - the Orangepip Kona328 and ALMOST everything lines up just fine.

I DID find that with the reset button fitted the case wouldn't quite snap together. The reset button was being fully depressed before the two parts were fully mated.

Carefully removing a mm or so off the bottom of the reset button /guide tube - on Case 2 -allowed the button to lift slightly. Problem cured, case halves go together like a dream and the button works perfectly.

Thanks for a great design.