ToolBox for Creality K1 /K1C

05/19/24 - Added V2 tool box model for K1C (Added storage space for a new type of nozzle (K1C) and added strength for the filament clip

03/28/24 - Added larger models of the toolbox for K1 and K1C, moved some parts and added a scraper in case the bundled one is broken!

I was inspired to create this model because the tools in the

kit

were always scattered and there was no place for them, so I

created a model of a printer toolbox for the entire set

and not only.

After you purchase this toolbox, you will have access to

other models

for stacking new bits or knives, a box for

for blades, a drawer for the control display, and clamps for

connecting the

right and left toolboxes.

You can choose from 5 types of left and 4 types of right

drawers and their subtypes, e.g. with and without logo,

with and without holder

Left toolboxes:

1) Creality K1 V1 toolbox - 1 model without fixators (can

be freely removed from under the printer).

2) Fixator V2 toolbox - model with locking tabs (can be freely removed from under the printer).

install, lift the printer and slide the box under it, once

installed, the box cannot be pulled out all the way).

3) Creality K1 V3 Tool Box - model with an updated

front design and locking tabs.

4) Tool Box V4 - updated design and hex key holder

5) ToolBox K1/K1 MAX - a model suitable for K1 and

K1 MAX

Right tool box:

1)Box for caliper V3 - model that holds caliper bit boxes

2)Right box V3 - model for your tools and bit boxes

3)Empty - empty box and without new front

4)Box for caliper V4 - Updated design and added section

The rest:

1)For nozzle assembly - an organizer for your nozzles

2)To assemble the knives - an organizer for your knives

3)Nozzle and knife - 2 models in one file

4)Overlay on the past version - front part of the toolbox for

version 3 (which you can glue on version 1 of the toolbox)

5)Fixator - fixator for the 1st version of the toolbox if you

want it not to pull out from under the printer completely.

6)Screwdriver bit box - a box for the bits in the right hand

box

7)Clips - clips for connecting the right drawer and with the

left drawer

8)Hex wrench holder no logo - separate file with hex

wrench holder no logo

9)Hex wrench holder - separate file with hex wrench holder

with logo

10)Fixator V4 - fixators for connecting the right and left

drawers version 4

Slicer: Creality print

Plastic: Hyper PLA

Layer height: 0.20

Line wight: 0.42

Wall lines: 2

Filling: 15%

Temp nozzle: 220°

Temp bed: 50°

Print Speed: 200.00

Infill Speed: 200.00

Outer Wall Speed: 140.00

Inner Wall Speed: 160.00

Top Surface Skin Speed: 140.00

Top/Bottom Speed: 140.00

Cooling:off

You can print on the default

settings

the model is very easy to print