Fantasy Masturbator Type: Meru

Merfolk Women appear light and tender but be carefull, you are in their Element now...

Update: Two new Variations, one without Jewels and one with a different set of Jewels! Both with their own Molds!

This is the first "full-body" Masturbator I'm releasing, based on the Zora race from BotW. There is also a 2 part and a 4 part model as well as a Mold that should even fit on small SLA printers.

There is also a Model without the Jewlery, although without the Mold or pre-cut parts.

And as an extra goodie I'm adding the lower-detail version of my Dildo Design "Meru" -> https://cults3d.emulatorsite.com/en/3d-model/naughties/dragon-fantasy-dildo-type-meru

I used a simple Mars Pro printer to print the 4-part mold. There's other ways of doing this too but I'll explain my way.

1. When printing the parts make sure to not use s on the inside as that would cause imperfections. It's certainly possible to print all parts without touching the inner walls.
   Note: keep the walls where the parts connect at 90° angles for less seams when you put it together.
   1.1(this should be obvious but take extra effort into cleaning the parts in pure alcohol to remove any and all excess resin. The fins can be tricky!)

2. When you harden the parts they can deviate from their original form since they are, well not hard yet. Either lay them flat or them somehow or use clamps and put the parts together how they should assemble. They will press against each other and tighten the gaps from any deformation from the printing process (at least to some extend)

3. Cure them thoroughly!
   Uncured resin inhibits the hardening process of the liquid resin.
   I let mine lay in a UV box or direct sunlight for at least 2 weeks and longer.
   To check if it's cured enough, fill in the shoulder or hip fins with silicone and check if hardens. If it doesn't then you need to clean it and cure some more.

2.1 you may try to sand it if you got the tools for that. Or you may try to cover it in some lacquer although some lacquers inhibit curing as well. I learned the hard way. Do spot testing first.

1. Pouring. Get a platinum curing silicone. Smooth on eco flex 00-20 to 00-50 are commonly used. Check the volume of silicone that you need for your size. For a good handheld size it's about 1 litre. Vacuum the mixed silicone to eliminate tiny air bubbles that could house bacteria. It's for your health.

And then pour it and have fun!