Surprise Egg Stitched/Knitted Articulated Dragon and Egg Package!

View our printing/assembly video here: https://youtu.be/prQ35O5gD4U

This is our new surprise egg and articulated stitched/knitted articulated dragon and egg model package! All of the models can be printed without s (except the bottom of the 2-piece egg), and the dragon models are print in place. The model package includes 2 versions of the stitched dragon egg, and 2 versions of the stitched articulated dragon model. For the stitched dragon egg, there is a single-piece model that can be printed in vase mode/spiral contour to seal a dragon model inside for a surprise egg. There is also a 2-piece version that uses 2mm x 7mm magnets (8 magnets total for each egg) to hold the pieces together so that it can be reusable. The link for the magnets is listed below. If you scale the 2-piece egg model smaller, the magnets will no longer fit. For assembly and print info, please view our printing and assembly video in the link above. The models have been heavily tested, and there were no problems with any of the models that we could find.

Link to 2mm x 7mm magnets used: https://amzn.to/4a1XMbZ

For the stitched dragon, there is a straight-line version and a curled version of the model. The curled version is for scaling up to print it bigger. The model looks best printed large, as the stitching detail is somewhat small on the body pieces. If you would like to only purchase the dragon egg or articulated dragon instead of the combo, we have included the links to each below:

Stitched/Knitted Articluated Dragon Model Only: https://cults3d.emulatorsite.com/en/3d-model/game/stitched-knitted-articulated-dragon-fidget-toy-model

Stitched/Knitted Dragon Egg Model Only: https://cults3d.emulatorsite.com/en/3d-model/game/stitched-knitted-dragon-egg-model-package-for-surprise-eggs

This design, like all Make It Lab designs, is under copyright. Which means, upon purchase, you do NOT have the right to sell commercially. If you would like to legally sell them commercially, please consider ing our Patreon:

https://www.patreon.com/MakeItLab

The Digital files are never to be re-sold, shared, or given away!
Please consider subscribing to our Youtube channel here: https://www.youtube.com/channel/UCnXgPCj_NgizXnv_ArxK2TQ

I printed the stitched eggs/dragons with the following settings:

3D Model slicer: Cura version 4.13.1
3D Printer: ANYCUBIC Kobra 2 Neo
Layer Height: 0.15 mm
Nozzle temperature: 205 degrees C
Bed temperature: 60 degrees C
Retraction speed: 35 mm/s
Retraction distance: 0.8 mm
walls: 3
Print speed: 50 mm/s
Infill percentage: 15%
Infill pattern: Gyroid
type: None (tree for the bottom of the 2-piece egg)
interface pattern: N/A
Build plate adhesion: Raft for adhesion