Solar Sphere organizers

Organizers for Solar Sphere board game. Quick game set up and comfort during the play.

Bcs of limited space in the game box, only version for cards without sleeves is available. 2 organizers have lids preventing small components from falling out during the storage. All organizers fit the game box as an insert.

The set contains: Players' component organizer, Resources organizer, White organizer, Card tray, Hex organizer and Puzzle organizer.

1. PLAYERS' COMPONENT ORGANIZER: There was not enough space in the game box to design a comfortable organizer for each player. So there's a collective container. Each player's cubes are separated from their other components. It facilitates game set up a bit. Rounded bottom of each section facilitates taking components out. This organizer has no lid, but it is covered by other containers and players' boards above. It provides some sort of security.
2. RESOURCES ORGANIZER: 3 types of resources: ore, gold and crystal are accommodated here in separate sections. Rounded bottoms facilitate the draw. Sliding lid prevent components from falling out during the storage. It was essential as this container is placed vertically into the game box.
3. WHITE ORGANIZER: A small organizer that contains white components (cube and Corporation drones) and Morale tokens. It also has a lid.
4. CARD TRAY: 3 decks of 3 types of Crew cards are organized here in separate sections. They're ready for the game set up. Other cards are accommodated in the second identical Card tray: Solo, Resistance ship cards and Location Cards + Sphere Scoring Cards + Faction tracks. Card trays are short to fit the game box. Still, they're high enough to contain corresponding decks. Indentations facilitate taking cards out.
5. HEX and PUZZLE ORGANIZERS: To build a Solar Sphere you need Hexes and Border tiles (puzzles). They are accommodated in 2 corresponding organizers. Indentations facilitate taking tiles out.

Photos in higher resolution:
The set
Packing steps
Organizers
Photos on imgBB

All organizers were 3Dprinted on Prusa MK4 (with Input Shaper):
- in PLA (Nebula Majestic Gold),
- No is needed,
- Infill 10% gyroid,
- 8 top layers.
Note1: Printing settings with 0.15 mm layer height are recommended for organizers with lids, so they work smoothly. I used slightly changed default Print settings "0.15mm SPEED MK4" in PrusaSlicer.
Note2: Containers and trays with no lid were 3d printed with 0.20 mm layer height settings.

Printing Time (for one piece of each kind):
3h9' - Players' component organizer
1h43' - Resources organizer, container
40' - Resources organizer, lid
53' - White organizer,
19' - White organizer,
53' - Card tray, x2
1h15' - Hex organizer
46' - Puzzle organizer