Minnie Urban Vibes

Hello, if you have problems try to set angle of at 35°

Thank you I will try that , I’m fairly new to 3d printing so I’m still learning !!

Dont worry if you need help you can send me direct message on fb or Instagram and i will help you.

Hi , just wanted to let you know that I changed the angle to 35 and it’s printed perfect , thanks for advising me on how to sort it

Thank you my friend for your , i m happy for this!!!

Please can u tell me wich printer do you use? Thank you.

Hi, to better understand the issue and correct it if necessary, I would need some additional information: what type of printer are you using (FDM or resin), and what model? Also, what specific problem are you encountering—are the ts too tight or too loose? The tolerances I used to create the fittings were tested on my Kobra 3 and Bambu Lab printers, but other printers might require some setup adjustments. Please let me know where I can intervene.
Best regards.

Hello, the printer I use is Bamboo Lab A1 and Creality Hi. I used exactly the settings you indicated. Not a single part fit.

Ok, and the ts are too tights or too loose, sorry for so much questions but need to understand where is the problem.

You scaled the model?

Hello my friend, the model is tested directly by me and didn't find any problem, wich problem have you found while you print?

Nicht beim Drucken sondern beim zusammensetzen.Die Teile en überhaubt nicht zusammen.

Non saprei come risponderti, ho testato personalmente gli incastri, ho anche fatto dei video dove attacco le parti senza colla, ho ricevuto delle immagini di minnie completata e con gli incastri perfettamente funzionanti. Forse è un problema di settaggi della tua stampante? Che tipo di stampante hai?